Hypertherm powermax1000 User Manual

OPERATION
0
4-2 powermax1000 Operator Manual
Controls and Indicators
6.0
BAR
5.04.0
PSI
80
7050 60
50
30
AMPS
60
20
V
AC
+
_
40
Current
(Amps)
Adjustment
Knob
Mode Switch
Indicator
LEDs
Pressure
Gauge
Pressure
Regulator
ON (I) / OFF (0)
Switch
Green Power ON LED
When illuminated, indicates that power is applied to system and power switch is ON ( I ).
Gas Pressure LED
Yellow: When flashing, indicates that the gas pressure is below 60 psig (4.1 bar) for cutting,
or 40 psig (2.8 bar) for gouging.
Green: When illuminated, indicates acceptable gas pressure for torch operation.
Yellow Torch Cap LED
When illuminated, indicates that the Retaining Cap is loose or not installed.
NOTE: Condition must be corrected and power turned OFF then ON to clear LED.
Yellow Temp LED
When illuminated, indicates that the power supply temperature has exceeded its operating
limit.
Red Fault LED
When illuminated, indicates that a fault condition exists, which prevents system operation.
Yellow Low Line Voltage LED
When illuminated, indicates that line voltage is below 170 VAC or above 680 VAC. On CE
units, it can also indicate a missing phase.
AC
V
Indicator LEDs

Hypertherm powermax1000 Specifications

General

Brand	Hypertherm
Model	powermax1000
Category	Welding System
Language	English