4-3
It takes about 100 operation hours to enhance its
designed performance.
Operate according to below three steps and avoid
excessive operation for the initial 100 hours.
Excessive operation may deteriorate the
Excessive operation may deteriorate the
potential performance of truck and shorten
potential performance of truck and shorten
lifetime of the truck.
Be careful during the initial 100 hours operation.
Check daily for the level and leakage of coolant,
engine oil, hydraulic oil and fuel.
Check regularly the lubrication and fill. Grease
daily all lubrication points.
Tighten bolts.
Warm up the truck fully before operation.
Check the gauges during operation.
Check if the truck is operating normally during
operation.
Replace following after initial hours of operation
Replace following after initial hours of operation
4)
Avoid excessive
operation for
initial 100 hours
2. SUGGESTION FOR NEW TRUCK
2. SUGGESTION FOR NEW TRUCK
1)
2)
※
3)
(1)
(2)
(3)
(4)
(5)
(6)
160D9LOP01
Service meter Load
Until 10 hours About 60%
Until 100 hours About 80%
After 100 hours 100%
Checking items Service
Engine oil
50Engine oil filter element
Pilot line filter
Axle gear oil
100
Transmission oil
Transmission oil filter
Brake cooling oil
To Next Page
Loading...
Need help?
General
