Handle assembly
1. Adjust the lower handle to the correct position for comfortable height, by aligning
the line on the mower body with one of the three lines on the end of the lower
handle. Fit the quick clips through the lower handle, and tighten (See Fig. 1).
Lines on the mower body
Line on the lower handle
Fig. 1
WARNING! The line on the mower body must be aligned with one of the
lines on the lower handle. And, the same line must be used for both sides
of the unit.
2. Place the upper handle over the upper ends of the lower handle. Align the holes.
Use the two sets of upper handle clips to secure (See Fig. 2).
Fig. 2
To Next Page
Loading...
Need help?
General
