Cleaning and maintenance
Cleaning
WARNING! Before cleaning, repairing, inspecting or carrying out any other
maintenance work, ensure that the blade is not rotating and that the safety
key has been disconnected.
• Keep all safety devices, air vents and the motor housing free of dirt and dust as
much as possible.
• Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
• Clean the equipment immediately after use with a damp cloth and some soft, non-
abrasive soap. Do not use cleaning agents or harsh solvents; these may damage
the plastic parts in the equipment. Ensure that no water penetrates the equipment's
interior.
• Do not clean the lawn mower with running water, particularly with high-pressure
water.
• Keep the handles dry, clean and free of oil and grease.
• At the end of the season, perform a general inspection of the lawn mower and
remove any grass, dirt or other debris that may have accumulated.
• At the start of each season, check the condition of the mower blade. If repairs are
necessary, please call the customer service center for assistance at on:
1646687880
Servicing
• Ensure that all mounting components (e.g. screws, bolts, nuts etc.) are always
tightened so that the equipment can be safely operated at all times.
• Frequently inspect the grass bag assembly for signs of wear and replace
immediately with a genuine Hyundai part if damage is found.
• Replace excessively worn or damaged parts immediately.
• To maximise your mower's longevity, all screwed parts, including the wheels and
axles, should be cleaned and lubricated.
• There are no parts inside the equipment which require additional maintenance or
lubrication.
Replacing the mower blade
Note: The mower blade is sharp and can cause severe personal injury if
handled incorrectly. Wrap the blade or wear protective gloves and use extra
caution when servicing.
• The cutting components are subjected to more wear and tear than any other
components on the unit. Therefore, routinely check the condition of the blade and
make sure that it is tightly fastened. If the blade is completely worn, it must be
immediately replaced or re-sharpened.
• An excessively vibrating mower means that the blade is not properly balanced
or has become deformed from striking an object. In this case, the blade must be
To Next Page
Loading...
Need help?
General
