Hyundai HYTR60Li User Manual

30
Cleaning and maintenance
3. Feed the line through the holes on either side of the spool casing. Each hole
should have one string coming out of it.
4. Replace the cover of the string casing. Make sure the lid snaps into place.
Repair
This product does not contain any parts that can be repaired by the consumer.
Contact an authorised service centre or a similarly qualified person to have it checked
and repaired.
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
Problem
Possible cause
Solution
1.Product
does
not start
1.1 Battery pack not properly
attached
1.1 Attach properly
1.2 Battery pack discharged
1.2 Remove and charge
battery pack
1.3 Battery pack damaged
1.3 Replace with a new one
of the same type
1.4 Other electrical defect to
the product
1.4 Check by a specialist
electrician
2.Product
does not
reach
full power
2.1 Battery pack capacity too low
2.1 Charge battery pack
3.1 Cutting attachment is worn
3.1 Replace with a new one
3.Unsatisfactory
result
3.1 Cutting attachment is worn
3.1 Replace with a new one

Hyundai HYTR60Li Specifications

General

Battery charger included	Yes
Type	String trimmer
Head type	-
Handle type	D-loop handle
Cutting width	330 mm
Product color	Black, Blue
Rotational speed	8000 RPM
Cutting diameter (max)	- mm
Power source	Battery
Charging time	0.75 h
Operating time	40 min
Battery voltage	58 V
AC input voltage	230 V
Battery capacity	2.5 Ah
AC input frequency	50 Hz
Battery technology	Lithium

Weight and Dimensions

Depth	1710 mm
Width	350 mm
Length	260 mm
Weight	4000 g
Package depth	1336 mm
Package width	240 mm
Package height	170 mm
Package weight	4640 g