5-82
LKA operation
To activate/deactivate LKA system:
With the ignition switch in the ON
position, press LKA system button
located on the instrument panel on
the left hand side of the steering
wheel.
The indicator ( ) in the cluster
display will initially illuminate white.
This indicates LKA system is in the
READY but NOT ENABLED state.
If you press LKA button located on
the instrument panel on the lower left
hand side of the driver, LKA will be
turned off and the indicator on the
cluster display will go off.
Note that the vehicle speed must be
at least approximately 64
km/h (40 mph) to
ENABLE the LKA sys-
tem. The indicator in the
cluster display will illuminate green.
- White : Sensor does not detect lane
markers or vehicle speed is
under 56 km/h (35 mph).
- Green : Sensor detects lane mark-
ers and the system is able
to control vehicle steering.
Information
If the indicator (white) is activated from
the previous ignition cycle, the system
will turn ON without any additional con-
trol. If you press the LKA button again,
the indicator on the cluster goes off.
LKA system operation
• To see the LKA screen on the LCD
display in the cluster, select Driving
Assist mode ( ). For more infor-
mation, refer to "LCD Display
Modes" in chapter 3.
i
Driving your vehicle
OAEPH059050L
OAEPH059627L
To Next Page
Loading...
Need help?
General
