68 Multi–Platform Interface Feature Operation Guide
Step2 – JES2 Definition (SYS1.PARMLIB)
RMT1 LUTYPE0,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,
NOCMPCT,SETUPHDR,CONSOLE
R1.PR1 CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,
F,T/C,P),CKPTAGE=30
DESTID NAME=LOC64XX,DEST=R1
Step 3 – Define to CICS or another
application program
Host commands for changing printer
settings are not supported in this mode.
Refer to the vendor documentation for
defining an DSC printer to the program for
its use.
Step 4 – Printer Settings
In LU0 mode the printer settings control the
CPI, LPI and all other aspects of the printed
output. Therefore, you must set the printer
settings to match the characteristics of the
job you are printing. Host controls are not
supported in this mode, except for the coax
Command Interpreter commands on page
19.
To Next Page
Loading...
Need help?
General