Related information
Installing a feature using the Hardware Management Console
Managing the Advanced System Management Interface
Removing the 8234-EMA, 9117-MMA, or 9406-MMA control panel with
power off
You can remove the control panel from the server with the power off. Use the Procedure in this section to
perform this task.
If your system is managed by the Hardware Management Console (HMC), use the HMC to complete the
steps for removing a control panel. For instructions, see Removing a part using the Hardware
Management Console. If you do not have an HMC, complete this procedure to remove a control panel.
If your system is managed by the IBM Systems Director Management Console (SDMC), use the SDMC to
remove the control panel from the server. For information about using the SDMC to remove a control
panel, see Removing a part by using the Systems Director Management Console. If you do not have an
SDMC, complete this procedure to remove a control panel.
To remove the control panel with the power off, complete the following steps:
1. Perform the prerequisite tasks described in “Before you begin” on page 25.
2. Stop the system. See “Stopping a system or logical partition” on page 30.
3. Disconnect the power source from the system by unplugging the system.
Note: This system might be equipped with a second power supply. Before continuing with this
Procedure, ensure that the power source to the system has been completely disconnected.
(L003)
or
20 Control panel, control panel fillers, and signal cables
To Next Page
Loading...
Need help?
General
