Table 46. Feature codes for Fibre Channel cables
Feature code Cable type Cable length Compatible Fibre Channel
host adapter features
1410 50 micron OM3 or higher
Fibre Channel cable,
multimode
40 m
(131 ft)
v Shortwave Fibre Channel
or FICON host adapters
(feature codes 3153, 3157,
3353)
1411 50 micron OM3 or higher
Fibre Channel cable,
multimode
31 m
(102 ft)
1412 50 micron OM3 or higher
Fibre Channel conversion
cable, multimode
2 m
(6.5 ft)
1420 9 micron OS1 or higher
Fibre Channel cable, single
mode
31 m
(102 ft)
v Longwave Fibre Channel
or FICON adapters
(feature codes 3253, 3257,
3453).
1421 9 micron OS1 or higher
Fibre Channel cable, single
mode
31 m
(102 ft)
1422 9 micron OS1 or higher
Fibre Channel conversion
cable, single mode
2 m
(6.5 ft)
Table 47. Multimode cabling limits.
Fibre cable type Distance limits relative to Gbps
2 Gbps 4 Gbps 8 Gbps 16 Gbps
OM1 (62.5
micron)
150 m 70 m Not
recommended
Not
recommended
OM2 (50 micron) 300 m 150 m 50 m 35 m, but not
recommended
OM3 (50 micron) 500 m 380 m 150 m 100 m
OM4 (50 micron) 500 m 400 m 190 m 125 m
zHyperLink adapters and cables
You can order zHyperLink adapters for your storage system configuration.
zHyperLink connections with IBM Z hosts provide low latency for random reads.
Storage systems with 12-core and higher processors are supported. I/O Priority
Manager must be disabled.
Note: The z-synergy Services license is required for zHyperLink.
Feature codes for zHyperLink I/O adapters
Use these feature codes to order zHyperLink I/O adapters for storage systems
with 12-core and higher processors.
Each zHyperLink connection requires a zHyperLink I/O adapter to connect the
zHyperLink cable to the storage system. Each zHyperLink I/O adapter card has
one port, but you must order them in sets of two. Depending on the system
configuration, zHyperLink I/O adapters can be ordered in quantities of 2, 4, 6, and
8.
Chapter 4. Storage system physical configuration 101
To Next Page
Loading...
Need help?
General