v Allow the packaged product to acclimate for 24 hours.
1
If there are visible signs
of condensation (either external or internal to the product) after 24 hours,
acclimate the system without the shipping bag for an additional 12 - 24 hours or
until no visible condensation remains.
v Acclimate the product away from perforated tiles or other direct sources of
forced air convection to minimize excessive condensation on or within the
equipment.
1
Unless otherwise stated by product-specific installation instructions.
Note: Condensation is a normal occurrence, especially when you ship equipment
in cold-weather climates. All IBM
®
products are tested and verified to withstand
condensation that is produced under these circumstances. When sufficient time is
provided to allow the hardware to gradually acclimate to the indoor environment,
there should be no issues with long-term reliability of the product.
Shipment weights and dimensions
You must ensure that your loading dock and receiving area can support the weight
and dimensions of the packaged storage system shipments.
You receive at least two, and up to three, shipping containers for each frame that
you order. You always receive the following items:
v A container with the storage system frame. In the People's Republic of China
(including Hong Kong S.A.R. of China), India, and Brazil, this container has a
plywood front door on the package, with a corrugated paperboard outer wrap.
In all other countries, this container is a pallet that is covered by a corrugated
fiberboard (cardboard) cover
v A container with the remaining components, such as power cords, CDs, and
other ordered features or peripheral devices for your storage system.
Table 72 shows the final packaged dimensions and maximum packaged weight of
the storage system frame shipments.
To calculate the weight of your total shipment, add the weight of each frame
container and the weight of one ship group container for each frame.
Table 72. Packaged dimensions and weight for storage system frames (all countries)
Container Packaged dimensions Maximum packaged
weight
DS8880 base frame (model 984)
Height 2.08 m (81.9 in.)
Width 0.95 m (37.4 in.)
Depth 1.50 m (59.1 in.)
1065 kg (2348 lb)
DS8880 base frame (model 985)
Height 2.08 m (81.9 in.)
Width 0.95 m (37.4 in.)
Depth 1.50 m (59.1 in.)
1250.5 kg (2757 lb)
DS8880 base frame (model 986)
Height 2.08 m (81.9 in.)
Width 0.95 m (37.4 in.)
Depth 1.50 m (59.1 in.)
1187.5 kg (2618 lb)
128 DS8880 Introduction and Planning Guide
To Next Page
Loading...
Need help?
General