8 IBM Flex System FC5022 16Gb SAN Scalable Switch User’s Guide
Product name and serial number
1
The hardware illustrations in this document might differ slightly from your actual hardware, and your
switch might have labels that are not shown in the captured illustrations.
You can manage and configure the switch through the following interfaces:
• An SSH connection to the command-line interface (CLI)
• A terminal emulation program connection to the mini-USB serial port interface
• A Web browser-based interface (Brocade Web Tools) connection to the switch
• The IBM Chassis Management Module (CMM)
For more information, seeChapter 2 “Installing the Switch”.
Product name and serial number
Record information about the switch in the following table. The product name and serial number
are on the identification label on the bottom cover of the switch. The media access control (MAC)
address is on a separate label on the bottom cover of the switch. For an illustration that shows the
locations of these labels, see
“Major components of the switch” on page 7. You will need this
information when you register the switch with IBM. You can register the switch at
http://www.ibm.com/support/mysupport/.
Removing the battery
Local regulations might require removing the battery prior to disposing or recycling this product.
Complete these steps to remove the battery:
1. Disconnect all power and communication cables from the front panel.
2. Remove all transceivers.
3. Unscrew the fasteners and remove the sheet-metal cover.
TABLE 3 IBM Flex System Solution Product Information
Product name IBM Flex System FC5022 16Gb SAN Scalable Switch
Model number
Serial number
Part number
Media Access Control (MAC) address
MAC address for other components
To Next Page
Loading...
Need help?
General
