21
STEP 9 – Additional Setup Options
At this point, you should proceed to the Setup chapter and continue to set
up your own selections for any other parameters such as those for the
display, keyboard, function/edit keys, and tabs.
Remember to repeat this procedure for Session 2 if you are running in dual
session mode. Use Ctrl-Enter (num) to access this set of parameters.
STEP 10 – Save Parameters
Finally, remember to save your Setup parameters in permanent memory, so
that they can be recovered if the terminal is powered down. When you exit
the Setup menu, the prompt “Save all? (Y/N)” flashes. To save parameters,
press “Y”. Another way to save parameters is to perform a “Save Terminal”
operation, while in the Exec (F13/Prnt Scrn) menu of Setup. Both methods
will save the parameters in both sessions, as well as those that are common
to both.
Remember to save your Setup settings after the entire installation
process.
STEP 11 – Establish Communications
Your installation is now complete. By pressing the Return or Enter key, you
should be able to communicate with the host computer(s). The printer
should respond to the local print command, Shift-Ctrl-. (period on numeric
keypad).
If for some reason, your installation was not successful, make sure your
physical connections are secure, that the communications protocol settings
match your devices and that the Setup selections are chosen to provide a
proper interface between the terminal and your devices.
If you continue to have problems installing the terminal, call your local
dealer for technical support.
To Next Page
Loading...
Need help?
General
