46
Save Labels: [Off, On]
When on, labels that are downloaded by the host will be saved in non-volatile
memory. If this selection and Display NV Labels are off, labels written by the
host would be lost upon entry and exit to Setup.
Attribute: [Char, Line, Page]
Choose the extent to which attributes are propagated. (The only parallel
ASCII emulations are PC Term and Wyse 60.)
Display NV Labels: [On, Off]
Select whether the labels in non-volatile memory are displayed on the lowest
line. When off is selected, any existing labels will remain on the screen, until
on is selected, and they are re-displayed. On a 26-line screen, they are
displayed below line 24. On a 44-line screen, labels are displayed below line
42, and on a 52-line screen, they are displayed below line 50. (The top line
is the top status line and cannot be used for data.) If the page length used is
a multiple of 25 (instead of 24) and the screen length is 26 lines , then the
last data line is used for data and labels will not be displayed regardless of
this setting. The same is true for a page length that is a multiple of 43
(instead of 42) with a screen length of 44 lines.
Status Line: [Standard, Extended, Off]
Select the type of the status line. In standard, cursor row and column,
session indicator, print indicator, Caps Lock, and communications mode are
displayed. In extended, only session indicator, Caps Lock, communications
mode, protect and write protect are displayed.
Char Set: [National, Multinational]
Select whether the character set used is the 7-bit national chart or the 8-bit
multinational chart when Language is not U.S. If U.S. is chosen, the
character set is multinational.
Enhanced Attributes: [Off, On]
When set to on, gives a better display presentation in overscan and reverse
video modes. The blink and dim video attributes will affect the foreground
text instead of the background. This selection is only available in reverse
video mode, on a per-session basis, and is disabled in a “split” display
screen.