65
NOTES:
1 This function is operational only if EIA (Aux) Rcv-Prtcl = Xon-Xoff/XPC or DTR.
2 In ANSI emulations, this keystroke toggles in and out of Auto Print Mode.
3 This function is operational even if Screen Saver is set to off.
4 This function unlocks the keyboard, turns off all print modes and re-initializes
the serial ports for setup parameters.
5 The length of the Break Signal is dependent on the setup parameter of “EIA (Aux)
Break.”
6 This keystroke is dependent on the “Disconnect” setting in the “Keys” (F5) setup
menu.
7 The Increment Scroll Rate toggles the scroll rate to the fastest smooth scroll. This
function also stops at the jump scroll. The Decrement Scroll Rate toggles from
jump scroll to the fastest smooth scroll toward the slowest smooth scroll.
8 These functions are not available in ANSI emulations.
9 The Change Status Line function will toggle in the status line display from
“Indicator” to “Host Write” to “Both” to “Off” in ANSI Emulations and “Standard”
to “Extended” to “Off” on ASCII Emulations.
10 For other keystrokes for these functions, see the Setup chapter.
11 Keystrokes for these functions are only operational if the “Desk Acc=
Sh-Ctrl-Fkeys” in the setup menu.
12 When a Split Screen is not enabled, these keys select the next or previous pages.
Wrapping takes place from the last page to the first and vice versa.
13 These local functions are operational only if the selected page is available.
To Next Page
Loading...
Need help?
General
