Figure 66. Disconnecting the signal cable and power cable
Replacing the drive backplane power cable in the 5105-22E, 9008-22L, 9009-22A,
9009-22G, or 9223-22H system
To replace a drive backplane power cable in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Using your labels, reconnect the power cable (B) to the drive backplane as shown in Figure 67 on page
73.
Push the connectors in until the latch clicks.
72
Power Systems: Power Systems: Drive backplane
To Next Page
Loading...
Need help?
General