Figure 77. Installing the service access cover
3. Push the system unit (B) back into the rack until both release latches of the system unit lock into
position.
Secure the cable management arm with hook-and-loop fasteners around the back side of the cable
management arm, but not around the cables.
4. Using your labels, reconnect the power cords (A) to the system unit.
Fasten the power cords to the system using the hook-and-loop fasteners (B) as shown in Figure 78 on
page 86.
Drive backplane cables in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, or 9223-22H
85
To Next Page
Loading...
Need help?
General