Figure 11. Removing the service processor card from slot P1-C1
Replacing the service processor card in the 9009-41A, 9009-41G, 9009-42A, 9009-42G,
9223-42H, or 9223-42S system
To replace a service processor card in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the insulator tab from the time-of day battery, to allow the time-of-day battery to make
contact with the service processor card as shown in Figure 12 on page 15
.
14
Power Systems: Power Systems: Service processor card
To Next Page
Loading...
Need help?
General
