4. Secure the enclosure with a screw in the rack mounting screw hole.
5. Reinstall the left and right end caps. (See Figure 11 on page 14.) The left end
cap has indicator windows that align with the status LEDs (light-emitting
diodes) on the edge of the enclosure.
a. Ensure that the serial number of the end cap matches the serial number on
the rear of the enclosure.
b. Fit the slot on the top of the end cap over the tab on the chassis flange.
c. Rotate the end cap down until it snaps into place.
d. Ensure that the inside surface of the end cap is flush with the chassis.
Installing options in the control enclosure
If you have purchased host interface adapters for your control enclosure and those
options were not preinstalled for you, you must open each node canister and
install the options.
Note: You must install the same options in all node canisters.
First, open the canister as described in “Opening the node canister” on page 16.
Then refer to the procedure for the option you are installing.
v “Installing an 8 Gbps Fibre Channel 4-port host interface adapter” on page 18
Finally, close the canister and install it in the control enclosure (see “Closing the
node canister” on page 21).
Note: Disk drives can also be installed in the control enclosure, but that procedure
does not involve opening any node canisters. See “Installing disk drives” on page
23 for details.
Chapter 2. Installing the hardware 15
To Next Page
Loading...
Need help?
General
