28. From the Actions menu, select Remove enclosure and confirm the action. The
physical hardware has already been removed. You can ignore the messages
about removing the hardware. Verify that the original enclosure is no longer
listed in the tree view.
29. Add the new enclosure to the system.
a. Select the system name from the tree view.
b. From the Actions menu, select Add Enclosures > Control and Expansions.
c. Because you have already added the hardware, select Next on the first
panel that asks you to install the hardware. The next panel shows the
unmanaged new enclosure.
d. Follow the steps in the wizard. The wizard changes the control enclosure
to Managed.
e. Select the enclosure and add it to the system.
30. Select the new enclosure in the tree view and verify that it is now online and
managed.
31. Change the enclosure ID of the replaced enclosure to that of the original
enclosure. From the Enclosure ID field, select the ID value of the original
enclosure.
32. Check the status of all volumes and physical storage to ensure everything is
online.
33. Restart the host application and any FlashCopy activities, Global Mirror
activities, or Metro Mirror activities that were stopped.
Replacing an expansion enclosure chassis
This topic describes how to replace an expansion enclosure chassis.
Note: Ensure that you know the type of enclosure chassis that you are replacing.
The procedures for replacing an expansion enclosure chassis are different from
those procedures for replacing a control enclosure chassis. For information about
replacing a control enclosure chassis, see “Replacing a control enclosure chassis”
on page 100.
Chapter 8. Removing and replacing parts 105
|
|
|
To Next Page
Loading...
Need help?
General