5. Pull out the handle to its full extension.
6. Grasp the canister and pull it out 2 or 3 inches.
7. Push the canister back into the slot until the handle starts to move.
8. Finish inserting the canister by closing the handle until the locking catch clicks
into place.
9. Verify that the cables were not displaced.
10. Verify that the LEDs are on.
Procedure: Powering off your system
Use this procedure to power off your Storwize V7000 system when it must be
serviced or to permit other maintenance actions in your data center.
To power off your Storwize V7000 system, use the following steps:
1. Stop hosts.
2. Shut down the system by using the management GUI. Click Monitoring >
System Details.FromtheActions menu, select Shut Down System.
3. Wait for the power LED on both node canisters in all control enclosures to start
flashing, which indicates that the shutdown operation has completed.
The following figure shows the LEDs on the node canisters. The power LED is
the LED on the left when the canister is top-side up.
4. Using the power switches, power off the control enclosures.
5. Using the power switches, power off the expansion enclosures.
6. (Optional) Shut down external storage systems.
7. (Optional) Shut down Fibre Channel switches.
Procedure: Collecting information for support
IBM support might ask you to collect trace files and dump files from your system
to help them resolve a problem.
The management GUI and the service assistant have features to assist you in
collecting the required information. The management GUI collects information
from all the components in the system. The service assistant collects information
from a single node canister. When the information that is collected is packaged
together in a single file, the file is called a snap.
1
svc00672
1
Figure 23. LEDs on the node canisters
Chapter 6. Resolving a problem 61
|
|
To Next Page
Loading...
Need help?
General