Disk Drive Initialization Procedure
This procedure
is
used to initialize new disk drives after they are installled in the
5363
system.
1.
Load the system from diskette
61:
a. Select function 3 (IPL Diagnostic Diskette).
b. Enter 22FF.
c.
Press the Start Function key.
2.
Select the option to initialize the new disk drive.
3.
Follow the prompts.
4.
After completion
of
the initialization procedure, do the following:
a.
To
perform
an
Auto Configuration, go to "321 Auto Configuring the System"
on
page 3-7.
b.
To
perform
an
SSP reload, go to "322 Reloading the SSP Diskettes"
on
page
3-8.
5.
This procedure is complete.
Section
8.
Disk Procedures 8-7
To Next Page
Loading...
Need help?
General