Icom IC-A25N User Manual

5
VOR NAVIGATION
5-3
1. Select a VOR station’s frequency.
• The CDI screen is displayed.
2. Push [F], and then push [OBS] to enter the OBS
mode.
• The OBS value is highlighted.
• The Course deviation is displayed, as shown below.
3. Push [ENT].
4. Confirm the TO/FROM indicator displays “TO.”
• If “FROM” is displayed, push [F], and then push [TO
FROM] to display “TO.”
5. Maintain the heading that the Course Deviation
Needle comes to the center of CDI.
NOTE: The IC-A25N and IC-A25NE’s VOR
Navigation features are supplemental aids to
navigation only, and are not intended to be a
substitute for primary VOR navigation equipment.
Flying to a VOR station
TIP: Using the Auto Bearing Set System (ABSS):
You can set your current heading as the course
heading.
Example:
Your OBS course heading is set to 045. However,
your current heading is 066 to the VOR. You want
to set your current heading as the OBS course
heading.
1. Push [F], and then push [TO FROM].
• “FROM 246” is displayed, and OBS is set to 246.
2. Push [F], and then push [TO FROM] again.
• “TO 066” is displayed, and OBS is set to 066.

Icom IC-A25N Specifications

General

Display type	LCD
Display diagonal	2.3 \
Backlight display	Yes
Battery type	BP-288
Battery life (max)	10.5 h
Number of batteries supported	1
Product color	Black, Grey
International Protection (IP) code	IP57
Operating temperature (T-T)	-10 - 60 °C
Antenna connector type	BNC
Purpose	Aviation Service (Air Band)
Maximum range	- m
Operating frequency	108 - 163.275 MHz

Weight and Dimensions

Depth	31.8 mm
Width	58.9 mm
Height	148.4 mm
Weight	340 g