Icom IC-F1710 User Manual

11
2
BASIC OPERATION
2
ï TX code number edit
If the transceiver has [TX Code CH Select] or [TX Code Enter]
assigned to it, TX code contents can be edited within the al-
lowable digits.
USING [TX CODE CH SELECT] KEY:
q Push [TX Code CH Select] to enter the TX code channel
selection mode.
• Select the desired channel before entering the TX code channel
selection mode if necessary.
w Push [TX Code CH Select] for 1 sec. to enter the TX code
edit mode.
e Push [TX Code CH Select] to select the desired digit to
be edited.
• The digit to be edited blinks.
r Push [CH Up], [CH Down] or 10-keypad*, or rotate [CH
Up/Down] to set the desired digit.
t Push [TX Code CH Select] to set the digit. The digit to the
right will blink automatically.
• When the 10-keypad* is used for setting, the digit to the right will
blink automatically without pushing [TX Code CH Select].
y Repeat r and t to input all allowable digits.
u Push [Call] or [PTT] to transmit the edited TX code.
*IC-F1810 or IC-F2810 only
USING [TX CODE ENTER] KEY:
q Select the desired TX code channel via [TX Code CH
Select]+[CH Up] or [CH Down], [TX Code CH Up], [TX
Code CH Down] or [TX Code CH Up/Down].
w Push [TX Code Enter] to enter the TX code edit mode.
e Push [TX Code Enter] to select the desired digit to be ed-
ited.
• The digit to be edited blinks.
r Push [CH Up], [CH Down] or 10-keypad*, or rotate [CH
Up/Down] to set the desired digit.
t Push [TX Code Enter] to set the digit. The digit to the right
will blink automatically.
• When the 10-keypad* is used for setting, the digit to the right will
blink automatically without pushing [TX Code CH Select].
y Repeat r and t to input all allowable digits.
u Push [Call] or [PTT] to transmit the edited TX code.
*IC-F1810 or IC-F2810 only

Icom IC-F1710 Specifications

General

Brand	Icom
Model	IC-F1710
Category	Transceiver
Language	English