6
Section 4
SETTINGS
You can turn the Beep function ON or OFF. When it is
OFF, the channel announcement is also turned OFF.
[ROTARY SELECTOR]
[VOL]
[Lower]
[Upper]
NOTE: Turn ON the Beep function when you set the
beep and announce level, ringer level, microphone
gain, squelch level, VOX function, VOX gain, or the
group code number, to check the current level setting
by hearing the beeps. (pp. 7 ~ 14)
Setting the Beep function
1. Rotate [VOL] to turn OFF the transceiver.
2. Set [ROTARY SELECTOR] to any channel other
than Channel 16.
3. While holding down [Lower], rotate [VOL] to turn
ON the transceiver and enter the Beep Level
Adjustment mode.
• An opening beep sounds and the selected channel
number is announced.
4. Push [Lower] to turn the Beep function ON or
OFF.
• When a beep sounds after pushing [Lower], the Beep
function is ON.
• When no beep sounds after pushing [Lower], the Beep
function is OFF.
L The transceiver stores the setting every time you
change it.
L If desired, push [Upper] to adjust the beep level. See
page 7 for details.
5. Rotate [VOL] to turn OFF the transceiver and exit
the Beep Level Adjustment mode.
To Next Page
Loading...
Need help?
General
