20
4
BIIS OPERATION
Direct code entry
D
While in the standby condition, push [TX Code Enter] to q
enter the TX code edit mode.
• Code digit for editing blinks.
Push [TX Code Enter] to select the desired digit to be ed- w
ited.
• Digit for editing differs according to the setting.
Set the desired digit using [CH Up]/[CH Down] or 10-key- e
pad*.
*IC-F3062T/IC-F4062T (10-key type) only
Push [TX Code Enter] to set the digit, then the digit to the r
right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [TX Code Enter].
Repeat t e and r to input all allowable digits.
y Push [Call] or [PTT]* to call.
* PTT call can be made only when PTT call capability is permit-
ted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“WAIT” is displayed during each call. However, an
error beep sounds and
“FAILED” is displayed when no
answer back is received after the calls.
u Push [PTT] to transmit; release to receive.
i Push [Moni(Audi)] to send the ‘Clear down’ signal.
For your information ✓
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.
To Next Page
Loading...
Need help?
General
