10
4
BASIC OPERATION
■ Adjusting the volume level
The volume level can be adjusted using [VOL/SQL] and [Y]
or [Z].
q
Push [VOL/SQL] once to enter the volume adjustment
mode, then push [Y] or [Z] to adjust the volume level.
• The “VOL” icon starts blinking.
• The transceiver has 31 volume levels and OFF.
• When no key operation is performed for 5 seconds, the trans-
ceiver returns to the normal mode.
w Push
[VOL/SQL]
twice to exit the volume adjustment
mode.
■ Adjusting the squelch level
The squelch level can be adjusted using [VOL/SQL] and [Y]
or [Z].
In order to properly receive signals, as well as for the scan
to effectively function, the squelch must be adjusted to the
proper level.
q
Push
[VOL/SQL]
twice to enter the squelch adjustment
mode, then push [Y] or [Z] to adjust the squelch level.
• The “SQL” icon starts blinking.
• The transceiver has 11 squelch levels: OP is completely open;
10 is tight squelch; 1 is loose squelch.
• When no key operation is performed for 5 seconds, the trans-
ceiver returns to the normal mode.
w Push
[VOL/SQL]
again to exit the squelch adjustment
mode.
Displays the
volume level.
Blinks in the volume adjustment mode.
Displays the
squelch level.
Blinks in the squelch adjustment mode.
To Next Page
Loading...
Need help?
General
