3
BASIC OPERATION
9
■ Call channel programming
The call channel is used to select channel 9, however, you
can program your most often-used channels in each channel
group for quick recall.
q While pushing [HI/LO], push [CH/WX•DW•U/I/C] one or
more times to select the desired channel group (U.S.A., In-
ternational, Canada) to be programmed.
w Push [16•9] for 1 sec. to select the call channel of the se-
lected channel group.
•“CALL” and call channel number appear.
•The order of indication precedence is “LOCAL,” “SP OFF” and
“CALL.”
e Push [16•9] again for 3 sec.
(until long beep changes to
2 short beeps) to enter call
channel programming con-
dition.
•Channel number starts flash-
ing.
r Rotate the channel selector
to select the desired chan-
nel.
t Push [16•9] to program the displayed channel as the call
channel.
•Push [CH/WX] to cancel.
•The channel number stops flashing.
■ Channel names
Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " # $
% & ' ( ) ✱ +
,
–
.
⁄) and spaces can be used.
q Select the desired memory channel.
•Cancel dual watch, tri-watch or scan in advance.
w While pushing [HI/LO], push [16•9] to edit memory chan-
nel name.
•A cursor appears and blinks.
e Select the desired character by rotating the channel selec-
tor or by pushing [Y]/[Z] on the microphone.
•Push [SCAN] or [CH/WX] for cursor movement.
r Push [16•9] to input and set the name.
•Push [HI/LO] to cancel.
•The cursor disappears.
t Repeat steps q to r to program other memory channel
names, if desired.
To Next Page
Loading...
Need help?
General
