22
5
REPEATER OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ General
When using a repeater, the transmit frequency is shifted from
the receive frequency by the offset frequency. It is convenient
to program repeater information into memory channels.
qSet the receive frequency (repeater output frequency).
wPush [FUNC] and
[
DUP
](4)
several times to select “–” or “+.”
• “–” indicates the transmit frequency is shifted down; “+” indicates
the transmit frequency is shifted up.
• Blinking “–” or “+” indicates the reversed duplex mode is selected
in
SET MODE
(p. 48).
ePush [FUNC] and [
TONE
](1) several times to activate the
subaudible tone encoder, if required.
•“ ” appears.
• Select the desired subaudible tone frequency, if necessary.
(p. 23)
rPush and hold [PTT] to transmit.
• The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
• If “OFF” appears, check the offset frequency (see next page for
details) and direction.
tRelease [PTT] to receive.
yPush and hold [MONI] to check whether the other station’s
transmit signal can be directly received.
■ Reversed duplex mode
When the reversed duplex mode is selected, the receive fre-
quency shifts.
(Transmit frequency shifts in normal duplex mode.)
Each receive and transmit frequency is shown in the table
below with the following conditions;
Input frequency : 145.30 MHz
Direction : – (negative)
Offset frequency : 0.6 MHz
qPush [FUNC], then push [
SET
](8) to enter
SET MODE
.
w Push [
YY
] or [
ZZ
] several times until “REV” appears.
e Rotate [VOL] to turn the reversed duplex mode ON or
OFF.
r Push [✱
ENT
] (or [CLR]) to exit
SET MODE
.
USING
SET MODE
Reversed OFF ON
Rx freq. 145.30 MHz 144.70 MHz
Tx freq. 144.70 MHz 145.30 MHz
To Next Page
Loading...
Need help?
General
