51
11
SET MODES
■ INITIAL SET MODE
The
INITIAL SET MODE
is accessed at power on and allows you
to set seldom-changed settings. In this way, you can “cus-
tomize” transceiver operations to suit your preference and op-
erating style.
DD
Entering INITIAL SET MODE
q While pushing and holding [
YY
] and [
ZZ
], turn power ON.
w Push [
YY
] or [
ZZ
] to select the desired item.
e Rotate [VOL] to select the condition or value.
•To exit
INITIAL SET MODE
, push [✱
ENT
] (or [CLR]).
DD
Key-touch beep
Turns key-touch beep emission ON (Beep level 1 to 3) or
OFF. (default: 3)
NOTE: The pocket beep level (Beep level 1 to 3 or OFF)
also changes as this setting.
DD
Time-out timer
To prevent accidental prolonged transmission, etc., the trans-
ceiver has a time-out timer. This function cuts a transmission
OFF after 1–30 min. of continuous transmission. This timer
can be cancelled.
• tOt.OF : The time-out timer is turned OFF.
• tOt. 1–30: The transmission is cut OFF after the set period
elapses. (default: 3)
• BE CAREFUL! The transceiver will become hot when
this time-out timer function is turned OFF and transmis-
sion is made for long periods.
• NOTE: When the battery pack (BP-227) becomes hot
from continuous transmittion, etc., the battery’s protection
circuit may activate to protect the battery itself and then
shut off the transceiver power until it has cooled down.
To Next Page
Loading...
Need help?
General
