Viceroy GT Range - Installation 19
ASSEMBLY
Boiler
It is not advisable to drain an installation, except in case of
absolute necessity. Check regularly the water level of the
installation and top it up if necessary, avoiding a sudden inlet
of cold water into the hot boiler.
This operation can only be done a few times a year;
otherwise, look for the leakage and remedy it without delay.
Cleaning of the flue gas circuit:
For this purpose:
- unhook the front cover,
- open the sweeping doors (upper doors)
by unscrewing the 3 lock nuts (19mm spanner)
- remove the baffles
- using the brush supplied, carefully sweep
the 8 flue ways
- also brush the baffles and the front face
- if possible use a vacuum cleaner
- put the baffles back in place
(pay attention to their direction)
- shut the door
The good performance of the boiler depends on its
degree of cleanliness.
Cleaning of the boiler must be carried out as often as
required and at least, as the chimney once a year or more,
according to the regulations in force. The following
operations are always carried out with the boiler and
the
power supply shut off.
9 MAINTENANCE
Hints for maintenance
Identification plate
Baffles (per flue way) GT 8 GT 9-10 GT 11-12 GT 13-14
Upper 8229-0010 2x8229-0010
then 2x then 3x
8229-0022 8229-0010 1x8229-0022 8229-0010
Middle 8229-0011 2x8229-0011
then 2x then 3x
8229-0023 8229-0011 1x8229-0023 8229-0011
Lower 8229-0012 2x8229-0012
then 2x then 3x
8229-0024 8229-0012 1x8229-0024 8229-0012
8229-EN-46 A
8229-EN-28
1
2
43or
To Next Page
Loading...
Need help?
General