To Next Page

To Previous Page

When two plinth sections meet, forming a corner,

you need to attach both plinth strips to the same leg.

In order to avoid the clips colliding, place the clips

upside down in one of the strips.

Note:



Installing the plinth

Generally, the base cabinets are supported by the sup-

porting strip along the wall and two legs in the front

of the cabinet. However, if you are going for a kitchen

with a plinth you also need to consider the following

steps:

Start with the plinth for the short side of the cabinet



sand the open edge before you apply the pre-glued

edge band that comes with the plinth.

For a plinth setup place the legs with the leg-plate

aligned to the cabinet edge. Since the plinth is

attached via the legs, you also need an additional leg

at the back of the open cabinet sides.

Follow the plinth assembly instruction to attach the



the leg since they will obstruct the attachment of

the plinth.

For the front plinth, place the plinth in position and

mark where you should cut it. After you’ve cut it,

repeat the process of attaching the edge band and



IKEA ENHET kitchen User Manual

Questions and Answers: