IKEA ENHET kitchen User Manual

8
Once all your base cabinets are installed, check that
they are level and that you are happy with the result,
before securing them by tightening the screws a

Once you are done with the installation of the wall
cabinets you move on to the base cabinets. Again,
start from the corner of the room and place the cabi-
net on the supporting wooden strip. If you build a line
kitchen, make sure you leave some space between the
wall and the cabinet to a allow for doors or drawers to
open properly.
If you have a corner kitchen, you build the corner base
solution with a 80 cm base cabinet in combination with


panel.
Note: 
built-in hob or for a built-in oven.
As you proceed with the next cabinet, level and align
the two cabinets by using a clamp. Use the screws
provided to attach the adjacent cabinets.
The dishwasher, normally placed next to the sink
cabinet, stands on its own base so here there is no
need for a supporting strip. Leave a 60 cm wide gap
between the sink cabinet and the next cabinet.
If you build a corner base solution with a 40 cm door,
place the cabinet 268 mm from the wall (A). If you
build it with a 60 cm door, place the cabinet 468 mm
from the wall (A). In both cases, the adjacent cabinet
is placed 688 mm from the wall (B).
Make sure that the corner panel and the front edge
of the adjacent cabinet align.
Fix the cabinet using the appropriate type and
length of screw. (Throughout the installation process
you may need to loosen the screws a bit in order
to make smaller adjustments when aligning the
cabinets and frames.)
To install a cabinet after the dishwasher niche, make
sure the spirit level reaches both cabinets at the
front and at the back of the cabinets. Make sure the
distance at the front and back of the niche remains

the cabinet to the wall.
When you install an open base frame, you don’t use
a supporting strip. Instead, align the top of the open
frame with the top of the adjacent cabinet before

When you reach the place where you want your

for sink, which has a construction that allows for



Installing the base cabinets/frames

IKEA ENHET kitchen Specifications

General

Brand	IKEA
Model	ENHET kitchen
Category	Indoor Furnishing
Language	English