ENGLISH 39
Errorcode Problem Possiblecause Solution
The hob switches
off and after 30
seconds emits an
acoustic signal
every 4 seconds
Continuous pressure
on control panel
area
Water or utensils on
control panel
Clean the control
panel
C81, C82 The control panel
switches off because
of excessively high
temperatures
The internal
temperature of
electronic parts is
too high
Wait for the hob to
cool down before
using it again
F42 or F43 The connection
voltage is wrong
The sensor detects
a discrepancy
between the
appliance voltage
and that of the mains
supply
Disconnect the hob
from the mains and
check the electrical
connection
F12, F21, F25, F36,
F37, F40, F47, F56,
F58, F60,
Call the After-Sales Service and specify the error code
Whattodoif...
Clean the hob after each use in order to
avoid damaging the surface and to prevent
the formation of baked-on deposits which
are difcult to remove. Before cleaning,
make sure the cooking zones are switched
off and that the residual heat indicator (“H”)
is not displayed.
Steam cleaner is not to be used!
Periodically check for dust under the
appliance, near the cooling air inlet or the
outlet openings.
This could hinder the ventilation and cooling
of the electronic module and decrease the
effectiveness of the hob.
To clean the hob, proceed as follows:
1. use a soft clean cloth, absorbent kitchen
wipes or a proprietary cleaner for glass
ceramic hobs. Do not use abrasive
sponges and/or metal scouring pads.
2. Food spills should be cleaned off before
they bake onto the glass ceramic
surface. Sugar and foods with a high
sugar content damage the glass ceramic
surface and must be immediately
removed using a scraper for glass.
Caution! Glass scrapers have a very
sharp blade and must be handled with
care.
3. Remove any stubborn food residues with
a scraper or proprietary detergents.
4. Salt, sugar and sand can scratch the
glass ceramic hob: clean up any such
spills on the hob immediately.
Maintenanceandcleaning
To Next Page
Loading...
Need help?
General