quantity).
How to set the rinse aid level
1. Press the on/off button to switch the appliance on.
2. Within 60 seconds after the appliance is switched on, press and hold for more than 5 seconds and then press to
enter rinse aid setting mode. The rinse aid indicator flashes.
3. Press repeatedly to toggle the following rinse aid levels on the display: D1 – D2 – D3 – D4 – D5 The higher the
number, the more rinse aid released by the appliance.
4. Press the on/off button to confirm the setting.
Before first use
1. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing residuals that can still be inside the appliance. Do not use
detergent and do not load the baskets.
After starting a programme, it may take up to 5 minutes for the appliance to recharge the resin in the water
softener. It seems that the appliance is not working.
The washing phase starts only after this procedure is completed. The procedure is repeated periodically.
The salt container
Caution! Use rough salt designed for dishwashers only. Fine salt increases the risk of corrosion. The salt is
used to recharge the resin in the water softener and to assure good washing results in daily use.
Filling the salt container
Fill the salt only when the salt indicator turns on.
Find the salt container at the bottom.
To Next Page
Loading...
Need help?
General
