`’4 in 1”, `’All in 1”). Follow the instructions written on the packaging.
Select the programme according to the type of load and degree of soil. With the ECO programme you have the
most efficient use of water and energy consumption for crockery and cutlery with normal soil.
Using salt, rinse aid and detergent
Only use salt, rinse aid and detergent for dishwasher. Other products can cause damage to the appliance.
In areas with hard and very hard water we recommend to use plain dishwasher detergent (powder, gel, tablets
containing no additional agents), rinse aid and salt separately for optimal cleaning and drying results.
At least once a month run the appliance with the use of appliance cleaner which is particularly suitable for this
purpose.
Detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware,
we recommend that you use the tablets with long programmes.
Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging.
What to do if you want to stop using multicables
Before you start to use separately detergent, salt and rinse aid do the following procedure.
1. Set the highest level of the water softener.
2. Make sure that the salt and rinse aid containers are full.
3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets.
4. When the programme is completed, adjust the water softener according to the water hardness in your area.
5. Adjust the released quantity of rinse aid.
6. Activate the rinse aid empty notification.
Loading the baskets
Refer to the supplied leaflet with examples of the load of the baskets.
Only use the appliance to wash items that are dishwasher-safe.
Do not put in the appliance items made of wood, horn, aluminum, pewter and copper.
Do not put in the appliance items that can absorb water (sponges, household cloths).
Remove remaining food from the items. · Soak items with remaining burned food in water.
Put hollow items (cups, glasses and pans) with the opening down.
Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery.
Make sure that glasses do not touch each other.
Put small items in the cutlery basket.
Put light items in the upper basket. Make sure that the items do not move.
Make sure that the spray arm can move freely before you start a programme.
Before starting a programme Make sure that:
The filters are clean and correctly installed.
The cap of the salt container is tight.
The spray arms are not clogged.
There is dishwasher salt and rinse aid (unless you use multi- tablets).
The position of the items in the baskets is correct.
The programme is applicable for the type of load and for the degree of soil.
The correct quantity of detergent is used.
Unloading the baskets
For better drying results keep the appliance door ajar for some minutes before you remove the dishes.
1. Let the dishes cool down before you remove them from the appliance. Hot dishes are easily damaged.
2. First remove items from the lower basket then the upper basket.
At the end of the program water can still remain on the sides and on the door of the appliance.
Care and cleaning
To Next Page
Loading...
Need help?
General
