Do not use high pressure water sprays and/or steam to clean the appliance.
If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet.
The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not
be reused.
Safety instructions
Installation
Warning! Only a qualified person can install this appliance.
Remove all the packaging and the transit bolts.
Do not install or use a damaged appliance.
Do not install or use the appliance where the temperature is less than 0 °C.
Follow the installation instruction supplied with the appliance.
Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear.
Make sure that the appliance is installed below and adjacent to safe structures.
Electrical connection
Warning! Risk of fire and electrical shock.
Warning! When positioning the appliance, ensure the supply cord is not trapped or damaged.
Warning! Do not use multi-plug adapters and extension cables.
Warning! Do not, under any circumstances, cut, remove, or bypass the grounding prong
The appliance must be earthed.
Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power
supply.
Always use a correctly installed shockproof socket.
Make sure not to cause damage to the electrical components (e.g. mains plug, mains cable). Contact the
Authorized Service Centre to change the electrical components.
Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to
the mains plug after the installation.
Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
This appliance complies with the E.E.C. Directives.
UK and Ireland only. This appliance is fitted with a 13 A mains plug. If it is necessary to change the mains plug
fuse, use only a 13 A ASTA (BS 1362) fuse.
Water connection
Do not cause damage to the water hoses.
Before connection to new pipes, pipes not used for a long time, where repair work has been carried out or new
devices fitted (water meters, etc.), let the water flow until it is clean and clear.
Ensure that there are no visible water leaks during and after the first use of the appliance.
The water inlet hose has a safety valve and a sheath with an inner mains cable.
To Next Page
Loading...
Need help?
General
