Problem Possible cause Solution
The pyrolytic cleaning is
not working (the display
shows “C2“)
The meat probe is not removed. Remove the meat probe. Close
the oven door, set the control
knob to off position and refer to
"Pyrolytic cleaning" section to ac-
tivate the function again
The pyrolytic cleaning is
not working (the display
shows “C3“)
The oven door is open. Close the oven door. Refer to "Py-
rolytic cleaning" section to acti-
vate the function again
Steam and condensa-
tion settle on the food
and in the oven cavity
Dishes have been left in the oven
for too long
Do not leave the dishes standing
in the oven for longer than 15-20
minutes after the cooking process
ends
“12.00” appears on the
display and the clock
LED is flashing
Interruption of the power supply Reset the time
F11 appears on the dis-
play
The plug of the meat probe is not
firmly in position in the socket
Insert the meat probe plug into the
socket in the side wall of the oven
as far as it can go
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
ution to the problem yourself, contact your
dealer or the After Sales Service.
If you operated the appliance wrongly, or
the installation was not carried out by a
registered engineer, the visit from the After
Sales Service technician or dealer may not
take place free of charge, even during the
warranty period.
Technical data
Dimensions (internal) Width
Height
Depth
395
335
400
Usable volumes 53 l
Area of largest baking sheet (net surface) 1130 cm²
Bottom heating element 1000 W
Top heating element 800 W
Full oven (Top + Bottom) 1800 W
Grill 1650 W
Full grill 2450 W
Thermal grill 1675 W
Fan cooking 2025 W
ENGLISH 15
To Next Page
Loading...
Need help?
General
