Push-pull control knobs The oven is provided with push-pull control
knobs. You can sunk the push-pull control
knobs inside the control panel when the oven
is off.
Turn the push-pull control knobs clockwise to
set the temperature and the oven function.
Before first use
Remove all packaging, both inside and
outside the oven, before using the appli-
ance. Do not remove the rating plate.
When you connect the appliance to the elec-
trical supply or in case of a power cut, the Time
function indicator flashes automatically.
To set the current time use the Temperature/
Time control knob. After approx. 5 seconds the
flashing stops and the clock displays the time
of the day set.
If the time of the day is not set the appliance
does not work.
Initial cleaning
Clean the appliance before first use. Clean the
accessories and the oven interior with a soft
cloth with warm water and soap.
After that preheat the oven up without food.
Preheating
Turn the oven function control knob to
and
run the oven for 45 minutes at maximum tem-
perature, to burn off any residue from the cav-
ity surface. Accessories can become hotter
than in normal use. During this period an odour
can be emitted. This is normal. Make sure the
room is well ventilated.
Daily use
Setting the oven function
1. Turn the oven functions control knob to the
desired function
The display shows a suggested tempera-
ture.
The oven starts to heat up.
2. When the appliance reaches set tempera-
ture, an audible signal sounds one time (4
short beeps) .
ENGLISH 6
To Next Page
Loading...
Need help?
General
