remove all wood chips and sawdust. Seal the
cut surfaces with a sealant to prevent from
moisture which could lead to swelling.
Protect the bottom of the appliance from
steam and moisture. Do not install the
appliance next to a door or under a window
to prevent hot cookware from falling o the
appliance when the door or the window is
opened.
Make sure that the space underneath the
hob is sucient for air circulation. The
bottom of the appliance can get hot. If the
appliance is installed above the drawers,
make sure to install a noncombustible
separation panel under the appliances to
prevent access to the bottom.
After installation, the bottom of the
appliance must no longer be accessible - risk
of burns.
Electrical warnings
Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power supply.
Before carrying out any operation make
sure that the appliance is disconnected from
the power supply.
Do not use extension leads, multi-plug
sockets or adapters. The appliance must be
earthed if the symbol ( ) is not printed on
the rating plate. Make sure that a shock
protection is installed. Use the correct
electricity mains cable. Use the strain relief
clamp on the cable. The electrical
components must not be accessible to the
user after installation.
Make sure the appliance is installed
correctly. Loose and incorrect electricity
mains cable or plug (if applicable) can make
the terminal become too hot. Make sure the
mains cable or plug (if applicable) does not
touch the hot appliance or hot cookware,
when you connect the appliance to a socket
nearby. Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the mains
plug after the installation.
The shock protection of live and
insulated parts must be fastened in such a
way that it cannot be removed without tools.
The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm. Use only
correct isolation devices: line protecting cut-
outs, fuses (screw type fuses removed from
the holder), earth leakage trips and
contactors.
To replace the power cable, contact the
Authorized Service Centre.
Concerning the lamp(s) inside this
product and spare part lamps sold
separately: These lamps are intended to
withstand extreme physical conditions in
household appliances, such as temperature,
vibration, humidity, or are intended to signal
information about the operational status of
the appliance. They are not intended to be
used in other applications and are not
suitable for household room illumination.
Before disposal, disconnect the appliance
from the mains supply. Cut o the mains
cable close to the appliance and dispose of
it.
ENGLISH
7
To download the full version visit www.ikea.com
To Next Page
Loading...
Need help?
General
