8
Displaying an image
Press the Power button.
The Power LED blinks green, and the fans start to
run. When the lamp comes on,
the start up screen displays and the Power LED turns solid green. It can take up to
a minute for the image to achieve full brightness. Note: When the feature, AC
Power On, is enabled, the projector automatically turns on when power is
connected. This allows control of ceiling mounted projectors with a wall power
switch.
No start up screen? Get help on page 12.
Turn on your computer or video device.
The image should appear on the projection screen. If it doesn’t, press the Source
but
ton on the
projector’s keypad or remote.
If you are using a VGA cable to connect your computer to the projector:
If using a laptop, make sure its external video port is active.
Many laptops do not automatically turn on their external video port when a
pr
ojec
tor is connected. Usually a key combination like FN + F8 or CRT/LCD key
turns the external display on and off. Locate a function key labeled CRT/LCD or a
function key with a monitor symbol. Press FN and the labeled function key
simultaneously.
Refer to your laptop's documentation for more information about your laptop's
key co
mbination.
No laptop image? Try pressing the Auto Image button on the remote. Get
help on
page 12.
turn on computer or
video device
activate laptop’s external port
monitor key or
LCD/CRT key
FN key
To Next Page
Loading...
Need help?
General
