5
Usage Guidelines
•
Do not look directly into the projection lens when the projector
is turned on. The bright light may harm your eyes.
NOTE: If the LitePro overheats
and turns off, you must wait about
30 seconds before you attempt to
turn it back on.
•
Do not block the grills on the projector. Restricting the air flow
can cause it to overheat and turn off.
•
Handle the projector as you would any product with glass
components. Be especially careful not to drop it.
•
Avoid leaving the projector in direct sunlight or extreme cold
for extended periods of time. If this happens, allow it to reach
room temperature before use.
•
Transport the projector in a vendor-approved hard or soft case.
Part numbers for these cases are listed on page 53. Call your In
Focus dealer to order.
If You Need Assistance
The first place to look for help is in this manual. Be sure to check
the guidelines in “Troubleshooting” on page 45.
If this manual doesn’t answer your question, call your In Focus
dealer. You can also call In Focus Customer Service directly at
1-800-799-9911
. Call between 6 a.m. and 5 p.m. PST, Monday
through Friday. In Europe, call In Focus in The Netherlands at
(31) 23-5623200
. In Singapore, call
(65) 740-6435
. Or, send us an
e-mail at
techsupport@infocus.com
Our World Wide Web address is
http://www.infocus.com
.
Warranty
This product is backed by a limited one-year warranty. The
details of the warranty are printed at the back of this manual.
Longer term warranties can be purchased from your In Focus
dealer. Refer to page 54 for part numbers.
Downloaded From projector-manual.com Boxlight Manuals
To Next Page
Loading...
Need help?
General
