8
Setting up the Projector
Connecting the CableWizard™ to the Projector
CAUTION: Turn off the
computer, monitor and projector
whenever you connect or
disconnect cables.
The CableWizard simplifies the connection process by providing
a central hub for all the connections between the projector and
your computer. The connectors on the CableWizard are labeled
with icons.
Connect the end of the CableWizard cable to the
connector on the projector’s connector panel (Figure 5).
NOTE: LitePro 730 is optimized
for use with CableWizard II. If you
have CableWizards from other
models of In Focus projectors, we
do not recommend using them
with the LitePro 730. Image quality
is reduced by using a CableWizard
other than Cable Wizard II. The
label on the bottom reads
CableWizard or CableWizard II.
F
IGURE
5
Connecting the CableWizard to the projector
Selecting Connectors on the CableWizard
NOTE: You must disconnect all
cables before turning the selector
on the CableWizard.
Turn the selector on the top of the CableWizard to reveal the
correct connectors for your computer.
F
IGURE
6
Selecting connectors on the CableWizard
Downloaded From projector-manual.com Boxlight Manuals
To Next Page
Loading...
Need help?
General
