USER GUIDE
• 23/28 Copyright © 2012 Ingenico
R11 900017771 000 02 All rights reserved
6. Standards
CE Marking
The CE marking indicates Move5000 complies with the requirements of European Directive
1999/5/EC of 9 March 1999 on Radio and Telecommunications Terminal Equipment for:
• the protection of the health and the safety of the user and any other person.
• the protection requirements with respect to electromagnetic compatibility.
and complies with harmonised standards.
Depending Move5000 model involved standards-are:
EU Directives :
According to harmonised EU standards :
Product Product Type Standards Issue date
USER GUIDE
• 24/28 Copyright © 2012 Ingenico
R11 900017771 000 02 All rights reserved
FCC/IC Compliance (2G/3G model)
The FCC ID for MOVE/5000 2G/3G Terminal model is:
XKB-MOV
and IC number is 2586D-
MOV
• This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception which can be determined by turning the equipment off
and on, the user is encouraged to try to correct interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
• In order to meet FCC and Industry Canada RF radiation exposure limits for general
population, this device must only be operated when held in the hand or in desktop
position with a minimum separation distance of at least 20cm from the user's body
and it must not be collocated or operated in conjunction with any other antenna or
transmitter. Use of this device with an accessory in order to be worn and operated
on user's body is strictly prohibited and will invalidate the certifications obtained for
FCC and Industry Canada.
• Afin de respecter les directives de la FCC et d’Industrie Canada concernant les
expositions radiofréquence, cet appareil ne doit fonctionner que tenu dans la main
ou sur station d’accueil avec une distance minimale d’au moins 20cm du corps de
l’utilisateur et il ne doit pas être en colocation ou coopération avec une autre
antenne ou émetteur. L’utilisation de cet appareil avec un accessoire dans le but
d’être porté et fonctionné sur le corps de l’utilisateur est strictement prohibé et
invalidera les certifications FCC et Industrie Canada obtenues
• This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
• Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
To Next Page
Loading...
Need help?
General
