MD021 Plastic Wire Drawing Machine User Manual
Chapter 6 Description of Function Codes
Group F0: Basic Function Parameters
0: Operation panel
1: Terminal input
2: Via
communication
This parameter specifies the input channel of inverter control
commands, such as start, stop, forward run (FWD), and reverse run
(REV).
0: Operation panel (the LOCAL/REMOT indicator is off.)
Commands are given by pressing keys RUN and STOP/RES on the
operation panel.
1: Terminal input (the LOCAL/REMOT indicator is on.)
Commands are given using multi-function input terminals such as
FWD and REV.
2: Serial port communication (the LOCAL/REMOT indicator blinks.)
Commands are given by the host computer. For details on the
communication protocol, see "Modbus Serial Communication
Protocol for the Plastic Wire Drawing Machine."
To Next Page
Loading...
Need help?
General