MD380 User Manual Desc
ription of Function Codes
- 231 -
Group A2: Motor 2 Parameters
The MD380 can switch over running between twomotors. For the four motors, you can:
Set motor nameplate parameters respectively
Perform motor auto-tuning respectively
Select V/F control or vector control respectively
Set encoder-related parameters respectively
Set parameters related to V/F control or vector control independently
*URXSV$FRUUHVSRQGVWRPRWRU$OOSDUDPHWHUVLQJURXS$KDYHWKHVDPHGH¿QLWLRQ
and usage as parameters of motor 1. For more details, refer to the descriptions of motor 1
parameters.
Function Code Parameter Name Setting Range Default
A2-00 Motor type selection
0: Common asynchronous motor
1: Variable frequency asynchronous motor
0
A2-01 Rated motor power
±N:
Model
dependent
A2-02 Rated motor voltage
1–2000 V
Model
dependent
A2-03 Rated motor current
±$$&GULYHSRZHUN:
±$$&GULYHSRZHU!N:
Model
dependent
A2-04
Rated motor
frequency
0.01 Hz to maximum frequency
Model
dependent
A2-05 Rated motor speed
1–65535 RPM
Model
dependent
A2-06 Stator resistance
0.001–65.535
:
$&GULYHSRZHUN:
0.0001–6.5535
:
$&GULYHSRZHU!N:
Model
dependent
A2-07 Rotor resistance
0.001–65.535
:
$&GULYHSRZHUN:
0.0001–6.5535
:
$&GULYHSRZHU!N:
Model
dependent
A2-08
Leakage inductive
reactance
±P+$&GULYHSRZHUN:
0.001–65.535 mH (AC drive power > 55
N:
Model
dependent
A2-09
Mutual inductive
reactance
±P+$&GULYHSRZHUN:
±P+$&GULYHSRZHU!N:
Model
dependent
A2-10 No-load current
$WR$$&GULYHSRZHUN:
$WR$$&GULYHSRZHU!N:
Model
dependent
A2-27
Encoder pulses per
revolution
1–65535
1024
efesotomasyon.com
To Next Page
Loading...
Need help?
General