21
Insignia 32" 720p LED TV
www.insigniaproducts.com
• Select Ye s , then press ENTER if a cable box
is connected. A message asks how you
connected the cable box to your TV.
• Select AV, Component, or HDMI, then
press ENTER if you connected a cable
box to your TV using one of these
cables. Read the message, then press
ENTER to close the wizard.
• Select Coaxial, then press ENTER if you
connected a cable box to your TV using
a coaxial cable. Read the message, then
press ENTER to start the channel scan
(VHF channels only).
C If you select Satellite Box, a message asks
how you connected the satellite box to
your TV:
• Select AV, Component, or HDMI, then
press ENTER if you connected a satellite
box to your TV using one of these cables.
Read the message, then press ENTER to
close the wizard.
• Select Coaxial, then press ENTER if you
connected a satellite box to your TV using
a coaxial cable. Read the message, then
press ENTER to start the channel scan (VHF
channels only).
12 To watch TV, press INPUT, press
S or T to
highlight TV in the INPUT SOURCE list, then
press ENTER.
Understanding the basics
Turning your TV on or off
To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press (power) to turn on your TV. The power
indicator turns off.
3 Press (power) again to turn off your TV. Your
TV enters standby mode, and the power
indicator LED turns red.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The INPUT
SOURCE list opens.
2 Press
S or T to select a video input source, then
press ENTER.
You can also press a Quick Launch Input button to
select the video input source.
• Press TV to select TV.
• Press VIDEO to select component or composite
input.
•Press HDMI once to select HDMI1. Press twice to
select HDMI2. Press three times to select HDMI3.
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
OK
ENTER
MENU
EXIT
MOVE
EXIT
PREVIOUS
SELECT
Coaxial
AV, Component, or HDMI
How did you connect the cable box to the TV?
OK
ENTER
MENU
EXIT
MOVE
EXIT
PREVIOUS
SELECT
Coaxial
AV, Component, or HDMI
How did you connect the satellite box to the TV?
Warning
When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the
power cord.
Note
If your TV does not receive an input signal for several
minutes, it automatically goes into standby mode.
TV
Component
VGA
USB
INPUT SOURCE
AV
HDMI1
HDMI2
HDMI3
NS-32E320A13A_12-0417_MAN_V1_ENG.book Page 21 Sunday, May 27, 2012 1:03 PM
To Next Page
Loading...
Need help?
General