37
32" 720p/43" 1080p 60Hz LED TV
www.insigniaproducts.com
• If you select Cable from the wall or Antenna
your TV starts scanning for channels and
displays a progress screen.
15 Press ENTER to close the wizard. If you selected:
• Cable from the wall, or Antenna, your TV tunes
to the first channel it found in the scan.
• Cable/Satellite box, press INPUT to open the
INPUT SOURCE list, press
or to select the
video input (HDMI or AV) you connected the
box to, then press ENTER. Your TV switches to
the input you selected.
Understanding the basics
This section covers basic information for:
• Turning your TV on or off
• Selecting the video input source
• On-screen menu overview
• Navigating the menus
• Selecting a channel
• Adjusting the volume
• Viewing channel information
Turning your TV on or off
1 Make sure that the power cord is connected to a
power outlet.
2 Press (power) to turn on your TV. The power
indicator turns off.
3 Press (power) again to turn off your TV. Your TV
enters standby mode, and the power indicator
turns red.
Note
You can press EXIT to stop the auto channel
search, but you will need to run the auto
channel search again to create a channel
list.
Warning
When your TV is in standby mode, it is still
receiving power. To completely disconnect
power, unplug the power cord.
Note
If your TV does not receive an input signal
for several minutes, it automatically goes
into standby mode.
To Next Page
Loading...
Need help?
General