Insignia NS-DXFL2C User Manual

8
NS-DXFL2C External TTL Flash for Canon™
www.insigniaproducts.com
3 Rotate the locking knob on the mounting foot until it’s tight. Do not
overtighten.
Removing the flash
• Make sure that the camera and flash are turned off, then remove the
flash from the camera by loosening the locking knob and sliding it off
of the camera’s hot shoe.
Turning on the flash
1 Slide the power switch to ON. The flash begins charging. The flash
zoom mechanism also resets. This generates some movement sounds
and is normal.
2 When the flash-ready indicator turns red, the external TTL flash is
fully charged and ready for firing.
Note
If the battery icon blinks on the back of the flash head,
the battery power is low and the flash stops charging. Change
the batteries immediately.
Note
To test the flash, press the TEST button.
Caution
Do not look closely at the flash window or point it at someone’s
eyes at close range.
NS-DXFL2C_14-1135_MAN_V2_ENG.fm Page 8 Thursday, October 16, 2014 3:18 PM

Insignia NS-DXFL2C Specifications

General

Brand	Insignia
Model	NS-DXFL2C
Category	Camera Flash
Language	English