15
NS-WC45BK7
www.insigniaproducts.com
Moving your wine/beverage cooler
1 Turn off the cooler and unplug it from the wall outlet.
2 Remove all wine/beverages.
3 Securely tape down all loose items inside your cooler.
4 Tape the door shut.
Make sure that the cooler stays in the upright position during
transportation.
Tips on saving energy
• Locate your cooler in the coolest area of the room, away from heat
producing appliances or heating ducts and out of the direct sunlight.
• Overloading the cooler forces the compressor to run longer.
• Do not open the door too often, especially if the weather is very hot. Close
the door as soon as possible to prevent cool air from escaping.
• Make sure that the appliance is sufficiently ventilated, with adequate air
circulation behind it.
Troubleshooting
Error codes
If a fault is detected, the display shows one of the following codes:
If any of these error codes appears on the display, please contact your local
dealer or service center. Do not try to repair the cooler yourself.
Failure codes
If there is a failure of the sensor, the screen may display failure code E or F.
When the screen displays one of these errors, do not attempt to disassemble
your cooler to check it yourself. You should contact local after-sales service
personnel for repair.
Caution
Use extreme caution with children. The unit should not be
accessible to child's play.
Fault Code E1 E2 E9
Description Temperature
sensor fault in
upper zone
Temperature
sensor fault in
lower zone
Communication
fault
To Next Page
Loading...
Need help?
General
