Intel Desktop Board DH61AGL Technical Product Specification
18
1.4 System Memory
The board has two SO-DIMM sockets and supports the following memory features:
• 1.5 V DDR3 SDRAM SO-DIMMs with gold plated contacts, with the option to raise
the voltage to support higher performance DDR3 SDRAM SO-DIMMs.
• Two independent memory channels with interleaved mode support
• Unbuffered, single-sided or double-sided SO-DIMMs with the following restriction:
SO-DIMMs with x16 organization are not supported.
• 16 GB maximum total system memory (with 4 Gb memory technology). Refer to
Section 2.1.1 on page 39 for information on the total amount of addressable memory.
• Minimum recommended total system memory: 1 GB
• Non-ECC SO-DIMMs
• Serial Presence Detect
• DDR3 1600 MHz, DDR3 1333 MHz, and DDR3 1066 MHz SDRAM SO-DIMMs
Note: DDR3 1600 MHz SO-DIMMs are only supported by 3
rd
generation Intel Core
processor family processors
NOTE
To be fully compliant with all applicable DDR SDRAM memory specifications, the board
should be populated with SO-DIMMs that support the Serial Presence Detect (SPD)
data structure. This allows the BIOS to read the SPD data and program the chipset to
accurately configure memory settings for optimum performance. If non-SPD memory
is installed, the BIOS will attempt to correctly configure the memory settings, but
performance and reliability may be impacted or the SO-DIMMs may not function under
the determined frequency.
Table 3 lists the supported SO-DIMM configurations.
Table 3. Supported Memory Configurations
Version
Capacity
Technology
Organization
Devices
A
1 GB 1 Gb 64 M x 16 8
2 GB 2 Gb 128 M x 16 8
B
1 GB 1 Gb 128 M x 8 8
2 GB 2 Gb 256 M x 8 8
C
512 MB 1 Gb 64 M x 16 4
1 GB 2 Gb 128 M x 16 4
F
2 GB 1 Gb 128 M x 8 16
4 GB 2 Gb 256 M x 8 16
8 GB 4 Gb 512 M x 8 16
Note: System memory configurations are based on availability and are subject to change.
To Next Page
Loading...
Need help?
General
